To my knowledge, the current file has to completely transferred to the requester before the next file can be requested. (The file overhead operation on both ends is always a problem in reading from the server. Reading files from Unraid will normally be much faster expect when you have large numbers of very small files. (The original design concept for Unraid was that it was to be a write-once, read-many system.) (One big file will transfer faster than a large number of small files.) If you are writing directly to the protected array, there are two methods of writing and one is faster than the other. (That is why it is named Unraid.) If you are transferring large files to Unraid, it will depend on whether you are using the cache drive(s) for the share. Having said all of that, Unraid does not have the same read-and-write speeds as a true RAID implementation. (At the time, the situation had gotten so bad that LimeTech was considering telling folks with RealTek NIC's with problems to get an Intel NIC based card.) A decision was made to use the open source driver that was packaged in the Linux distro that is used as the basis for Unraid. Things got so bad and confusing, that LimeTech finally threw their hands and surrendered. LimeTech, in the distant past, would use which ever driver gave the fewest problems- the RealTek one or the open-source one. The Windows driver was always their focus. To RealTek, in past years, Linux has been the ugly step-child. Thanks, and greetings from Switzerland 🙂
Or is there an other way to fix the problems? So is there a way to change the driver on unraid so it uses the official Realtek driver (r8168)? Memory at d0000000 (64-bit, prefetchable) Ĭapabilities: Power Management version 3Ĭapabilities: MSI: Enable- Count=1/1 Maskable- 64bit+Ĭapabilities: Express Endpoint, MSI 01Ĭapabilities: MSI-X: Enable+ Count=4 Masked-Ĭapabilities: Advanced Error Reporting Memory at d0004000 (64-bit, prefetchable) Subsystem: ASRock Incorporation Motherboard (one of many)įlags: bus master, fast devsel, latency 0, IRQ 16
RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 06) Using the command lspci -v confirms, that r8169 is used.Ġ2:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. The driver r8169 is the open-source one and the driver r8168 is the Realtek one. I found this Guide, how to change out the drive to the official Realtek driver, but apt-get is not used on unraid. In the Windows Setup, the LEDs kept blinking after shutdown.Īfter a google search, I found out that the Ethernet Chip is an Realtek RTL8111. I noticed that the LEDs on the Ethernet Port are completely off when the system is turned off. (Wake-On-LAN was working, speed about 850-900 Mbit) (about 500-600Mbit)īefore Unraid, this system was running on Windows 10 and I had none of those problems.
I have a test System here, i have unraid 6.8.3 up and running.ĬPU: AMD A4-5300 APU with Radeon™ HD Graphics 3400 MHz
0 kommentar(er)
